Controllers

4, 8, 12, 24, & 36 Station Models

Where to Buy

– Six independent programs that can run concurrently

  • Up to 9 daily cycle starts per program; or, loop watering optional in all six programs for unlimited cycles
  • No limit on the number of programs to which a station can be assigned (all six if desired)
  • Station timing adjustable from 1 minute to 24 hours in 1 minute increments. Seconds/minutes time base optional in all six programs. An illuminated LED lets you know if a program is in the seconds/minute mode

– Automatic, semi-automatic, manual, and timed manual operation

  • Programmable watering calendar. The watering calendar is factory set at 7 days, but can be changed to any length from 1 to 32 days
  • Programmable “system check” cycle that can be initiated at any station. Station “On” duration programmable from 1 min. to 15 min. (or 1 to 15 sec. per station)
  • Water budgeting feature to simultaneously change the watering duration of all stations within a program (1% to 255%).  An illuminated LED lets you know if water budgeting is set at other than 100%
  • Single program option gives you the flexibility of having two or more programs scheduled, but limiting automatic operation to only that program at which the dial is set
  • Programmable rain off up to 14 days. The controller will resume automatic operation on the day following the last “Off” day.
  • Program erase feature allows existing programs to be erased individually or all at once
  • Programmable pause of 1 second to 59 seconds between stations to allow full valve closure before advancing to the next station
  • Programmable loop allows a program’s watering cycle to continuously repeat for a desired period
  • Cycles can repeat immediately or after a programmed delay of 1 minute to 4 hours, 15 minutes
  • Program 6 can be activated by a sensor switch such as a thermostat. Ideal for frost protection or cooling

– Simplified program review

  • Program information can be scrolled on the display
  • Master valve/pump start circuit can be disabled during operation of any program
  • Master valve/pump start station can be turned on manually without another station turning on

Technical Information & Specifications

T1S1

  • Non-volatile memory holds program information during power outages of any length

TIS2

  • Ten year lithium battery (included) keeps real-time during power outages of any length

TIS3

  • Electronic circuit breaker identifies and overrides shorted solenoid valves

T1S4

  • Master valve/pump start circuit

T1S5

  • Wall or pedestal mount. Pedestal sold separately

TIS6

  • Weather-proof metal cabinet with lock and key

Electrical Specifications

Input

  • 120 VAC @ 50 or 60 Hz

Output

  • 24 VAC @ 50 VA

Notes

  • Maximum of two 4-watt solenoids per station. Maximum of five 4-watt solenoids to operate simultaneously, or, for solenoids with current draw below 0.25 Amps, up to six solenoids can operate simultaneously.

Pedestal Specifications

PS1

  • Heavy duty steel, rust resistant

PS2

  • Weather proof

PS3

  • Removable cover with lock and key

PS4

  • Partition to separate valve wires from power supply wires